Auto-K Plastic adhesion promoter Basic transparent 400ml

The Auto-K plastic adhesion promoter improves the adhesion of the subsequent paint application on plastic surfaces. It is suitable for most plastics (please observe the instructions on the label). Check plastics for compatibility. Note: Do not spray on surfaces coated with synthetic resin, as the paint may lift. The manufacturer recommends the following paint structure: 1. remove dust and grease from the plastic substrate with detergent 2. if necessary, sand with 600-grit wet sandpaper 3. apply a cross coat of plastic adhesion promoter 4. paint over the primed surface with Auto-K plastic paint spray.

Product details:

• for plastic parts, e.g. spoilers, plastic wing mirrors and bumpers
• ensures ideal adhesion
• dries quickly
• Very economical and easy to apply
• Content: 400 ml
• Color: transparent
• Binder base: special polymers
• Recoatable with itself and with all Auto-K paints after 15 minutes
• Spray application: Apply 1 thin cross coat 3-5 µm
• Drying times: dust-dry after 15 minutes, touch-dry after 30-40 minutes

Signal word:Danger

Pressurized container: may burst if heated.

H315 Causes skin irritation.

H319 Causes serious eye irritation.

H222 Extremely flammable aerosol.

EUH211 Warning! Spraying may produce hazardous respirable droplets. Do not breathe aerosol or mist.

Read all instructions carefully and follow them.

P332+P313 If skin irritation occurs: Get medical advice/attention.

P337+P313 If eye irritation persists: Get medical advice/attention.

P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove any contact lenses if possible. Continue rinsing.

P102 Keep out of the reach of children.

P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. Do not smoke.

P251 Do not pierce or burn, even after use.

P302+P352 IF ON SKIN: Wash with plenty of water.

P101 If medical advice is needed, have product container or label at hand.

P410+P412 Protect from sunlight. Do not expose to temperatures exceeding 50 °C/ 122 °F.